Comments on: Getting Started with ESP32 Cheap Yellow Display Board – CYD (ESP32-2432S028R)

By: Sara Santos

Sara Santos — Fri, 06 Jun 2025 09:55:15 +0000

In reply to Abhi.

Hi.
There’s probably something wrong with the initialization and declaration of the variables.
But, it’s hard to tell without knowing the exact example you’re following.

Regards,
Sara

By: Abhi

Abhi — Thu, 05 Jun 2025 11:41:47 +0000

I have a strange issue with my CYD. I have two functions that run on my cyd depending on if I select them. When func1 is the boot function it runs fine. However if I switch to func2 and then back to func1, the text does not refresh and the characters become solid white boxes after a few seconds becuase of the new characters overlapping. The same happens when func2 is the boot function. They are both the same in terms of how they print text and get new text but its only happeneing when the second function is called. Any idea if I need to reinitialkize the screen when I change functions?

By: Sara Santos

Sara Santos — Sat, 10 May 2025 09:28:26 +0000

In reply to Keith Mildenberger.

That’s great!
Thank you so much for your support.

Regards,
Sara

By: Keith Mildenberger

Keith Mildenberger — Fri, 09 May 2025 19:42:36 +0000

After many frustrating hours with this board your tutorial FINALLY helped me break through. Purchased the ebook as well. Great work n both fronts, keep up the good work it is greatly appreciated.
Thank you, Keith

By: Sara Santos

Sara Santos — Mon, 21 Apr 2025 09:35:46 +0000

In reply to Samuel.

Hi.
What is exactly the issue with your display?
Regards,
Sara

By: Samuel

Samuel — Sun, 20 Apr 2025 04:10:45 +0000

In reply to Dr Quark. Have the same issue. Did anyone find a solution, or did I just waste 20 bucks. It is not a cheap yellow display if it doesn't work. It is an expensive, ineffective paperweight.

By: Devin

Devin — Tue, 15 Apr 2025 15:05:04 +0000

(Solved) I have a ESP32-2432S028 board with one USB-C and one USB-micro connector. I kept getting: X = -17 | Y = -15 | Pressure = 4095. I also had a blank screen.

This is what worked for me: In the User_Setup.h on line 126: remove the “//”
#define TFT_INVERSION_ON

By: zan

zan — Sat, 05 Apr 2025 12:21:56 +0000

In reply to Sara Santos. HELP ME PLEASE..

By: Zan

Zan — Sat, 05 Apr 2025 11:11:25 +0000

I tryed out everyrhing but dont work…

By: zan

zan — Sat, 05 Apr 2025 11:10:18 +0000

HELLO, TNX FOR QUCK REPLAY,

WOULD YOU MIND TO LOOK IN TO SETUP_CONF.ZIP FROM MANUFACTURER,
THERE ARE PINOUTS SCHEMATICS AND DEMOS.
AND TELL ME HOW TO SETUP THE SCREEN, I CANT GET IT TO LIFE NO MATTER WHAT…..

we.tl/t-xUZCTUXs9h